USB C PD DC Voltage Trigger Test Module 9V 12V 20V Adjustable Power 5A 100W E-Mark Type-C

SKU: POWTRIG-E
UPC: 845832031903

• Power all kinds of electronic devices with USB-C PD chargers and power banks • Test power supply capabilities
• Performs real PD power negotiation • Supports up to 5A / 100W • Has the e-Mark chip necessary to unlock 5A output on 100W power supplies
• Trigger 5V, 9V, 12V, 15V, or 20V output (not all USB-C power supplies support all voltages) • The module just performs the PD negotiation and passes the output
• LED voltage indicators • Retains setting after power loss
• Power supply must be connected to the male end of the module

Instructions:
• USB-C power supply must support the PD protocol
• Basic operation: Connect the module to USB-C PD power supply. The LED indicates the current voltage. If no LED is illuminated then it is currently at 5V. While holding S+ press S- to unlock the board. Press S+ to increase voltage. Press S- to decrease voltage.
• Reset to 5V: Press and hold the S- button while connecting the module to the power supply
• Quick key unlock: After powering on, while holding S+, quick press S-
• Quick key lock: After powering on, while holding S-, quick press S+
• Permanent Key Lock: Press and hold the S+ button while connecting the module to the power supply. Press S+ or S- to enable or disable the key lock. If the key lock is enabled, then the voltage cannot be changed until it is unlocked.
• Test Mode: Press and hold S- and S+ simultaneously while connecting the module to the power supply. The output voltage will automatically cycle between all supported voltages.